Made from Aramid fibre, Mineral
fibre & Inorganic bounded with Synthetic NBR
Elastomers.
Applications:
Suitable for oils, fuels, lubricants, alcohols,
gases, hydrocarbons, steam, water, cooling liquids,
most diluted acids and alkalies for medium stress
conditions.
THICKNESS
:
0.25 mm to 6.00 mm. ( OTHER THICKNESS ON REQUEST)
COLORS
:
GREEN (OTHER COLORS ON REQUEST)
DIMENSION OF SHEETS
:
1500MM X 1500MM, 1500MM X 3100MM, 1500MM X 1000MM,
1500MM X 2000MM, 1270MM X 1270MM, 1270MM X 3810MM, 3000MM
X 3000MM
OPERATING CONDITION
:
Maximum internal pressure: 70 BAR
Maximum Temperature: 250°C
The following Information Applies to
material Thickness 1.5mm.
S.NO.
Typical Properties
Test Method
Unit
Specified Value
1
DENSITY
----------
Gm / cm3
1.50 - 1.90
2
TENSILE STRENGTH
a) ACC to ASTM F152
(ACROSS GRAIN)
N/MM2
6 Min.
b) ACC to DIN52910
(ACROSS GRAIN)
N/MM2
5 Min.
3
COMPRESSIBILITY
ASTM F36A
%
7 – 15
4
RECOVERY
ASTM F36A
%
³ 40
5
FLUID ABSORPTION
(a) IN ASTM OIL NO. 3
ASTM F 146
INCREASE IN MASS
%
≤15
INCREASE IN THICKNESS
%
≤10
(b) IN FUEL B
ASTM F 146
INCREASE IN MASS
%
≤10
INCREASE IN THICKNESS
%
≤10
(c) IN WATER/ANTIFREEZE
ASTM F 146
INCREASE IN MASS
%
≤15
INCREASE IN THICKNESS
%
≤5
6.
IGNITION LOSS
DIN 52911
%
≤ 40
NOTE
All information and recommendations given
in this brochure are correct to the best of our knowledge.
However, in view of the wide varsity of possible installation
and operating conditions one cannot draw the final conclusion in
all application cases regarding the behaviour in a gasket joint.
Therefore, information can only serve as a guideline.
