Made from Chrysotite Asbestos
Fiber with Synthetic Elastomers and Inorganic fillers.
Applications:
Suitable for use with internal
combustion engines, compressors, Refrigerators, chemical
plants, etc. This grade also provides effective sealing
against hot oils, tar oils and chlorinated &
aromatic hydrocarbons under high stress conditions.
1500MM X3100MM, 1500MM X1500MM, 1500MM X 1000MM, 1500MM
X 2000MM, 1270MM X1270MM, 1270MM X 3810MM, 3000MM X 3000MM
OPERATING CONDITION
:
Maximum pressure : 140 Kg/cm2
Maximum Temperature: 550°C
SPECIFICATION COMPLIANCE
:
IS: 2712 / 1998 GRADE O / 1, W / 1
The following Information Applies to
material Thickness 1.5mm.
S.NO.
Typical Properties
Test Method
Unit
Specified Value
1
Density
IS:2712/1998
g /cm3
1.70 - 2.20
2
Tensile Strength
IS:2712/1998
Mpa
>24.0
3
Compressibility
IS:2712/1998
%
6 -14
4
Recovery
IS:2712/1998
%
>40
5
Ignition Loss
IS:2712/1998
%
<28
6
Stress Resistance
IS:6210/1979
Mpa
>23
7
FLUID ABSORPTION
IN ASTM OIL NO.3
(a) Thickness Increase
IS:2712/1998
%
<25
(b) Mass Increase
IS:2712/1998
%
<20
IN FUEL B
(a)Thickness Increase
IS:2712/1998
%
<20
(b) Mass -Increase
IS:2712/1998
%
<20
IN WATER
(a) Mass - Increase
IS:2712/1998
%
<10
NOTE
All information and recommendations given
in this brochure are correct to the best of our knowledge.
However, in view of the wide varsity of possible installation
and operating conditions one cannot draw the final conclusion in
all application cases regarding the behaviour in a gasket joint.
Therefore, information can only serve as a guideline.
