| CJ - 21 Metallic |
| |
| Asbestos Gasket Jointing Sheet With Wire |
|
 |
| Material Composition: |
| Made from Chrysotite Asbestos
Fiber with Synthetic Elastomers with M.S Wire Reinforced |
| |
| Applications: |
| To seal off water, steam, air and
alkaline chemicals for low stress conditions. |
| |
| |
|
 |
|
| |
| THICKNESS
|
: |
0.80 mm to 6.00 mm. |
| SURFACE FINISH |
: |
Grey , Graphited |
| DIMESNSION OF SHEETS |
: |
1500MM X3100MM, 1500MM X1500MM, 1500MM X
1000MM, 1500MM X 2000MM, 1270MM X1270MM, 1270MM X 3810MM
|
| OPERATING CONDITION |
: |
Maximum pressure : 40
Bar Maximum Temperature: 415°C |
|
| |
| The following Information Applies to
material Thickness 1.5mm. |
| |
| S.NO. |
Typical Properties |
Test Method |
Unit |
Specified Value |
|
1 |
Density |
IS:2712/1998 |
g /cm3 |
1.80 - 2.10 |
|
2 |
Tensile Strength |
IS:2712/1998 |
Mpa |
>7.0 |
|
3 |
Compressibility |
IS:2712/1998 |
% |
6 – 14 |
|
4 |
Recovery |
IS:2712/1998 |
% |
>40 |
|
5 |
Ignition Loss |
IS:2712/1998 |
% |
<28 |
|
|
| NOTE |
| All information and recommendations given
in this brochure are correct to the best of our knowledge.
However, in view of the wide varsity of possible installation
and operating conditions one cannot draw the final conclusion in
all application cases regarding the behaviour in a gasket joint.
Therefore, information can only serve as a guideline. |
| |